This is the mail archive of the
cygwin
mailing list for the Cygwin project.
Re: "command not found"-For All Commands
On Sun, May 30, 2010 at 03:36:59PM -0700, physicist25 wrote:
>
>
>I did send the results of cygcheck...some slight changes since...
>
>"I ran cygcheck, its also attached as a .txt file. Notice how I had to add a
>"/" to the command to run it."
>
>-sh-3.2# cygcheck -s -v -r > cygcheck.out
>-sh: cygcheck: command not found
>-sh-3.2# cygcheck/ -s -v -r > cygcheck.out
>cygcheck: dump_sysinfo: GetVolumeInformation() for drive D: failed: 112
>-sh-3.2#
>
>
>I did this again, same results except now I dont have to use "/" when i
>write "cygcheck", the results of running the command are the same.
>
>http://old.nabble.com/file/p28725344/nocommandswork.txt nocommandswork.txt
This is what that oddly attached file shows:
-sh-3.2# cygcheck -s -v -r > cygcheck.out
-sh: cygcheck: command not found
-sh-3.2# cygcheck/ -s -v -r > cygcheck.out
cygcheck: dump_sysinfo: GetVolumeInformation() for drive D: failed: 112
-sh-3.2#
That shows you typing the commands but it doesn't show that actual output
from the commands.
cgf
--
Problem reports: http://cygwin.com/problems.html
FAQ: http://cygwin.com/faq/
Documentation: http://cygwin.com/docs.html
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple